LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1361 (Seat Belt System) >> Repair Instructions >> Seat Belt Height Adjuster Replacement - Front (Passenger Side) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Front Seat Shoulder Belt Retractor Tension Adjuster
    GM240010Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the passenger seat SIR System. Refer to SIR Disabling and Enabling Zone 9 in SIR.
  2. Remove the seat belt shoulder guide. Refer to Seat Belt Retractor Replacement - Right Front .
  3. Remove the front side door sill trim plate. Refer to Door Sill Plate Replacement in Interior Trim.
  4. Remove the rear side door sill trim plate. Refer to Door Sill Plate Replacement in Interior Trim.
  5. Remove the center pillar lower trim panel. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  6. Remove the center pillar upper trim panel. Refer to Trim Panel Replacement - Upper Center Pillar in Interior Trim.
  7. Remove the following components from the vehicle:
    • The bolt
    • The front seat shoulder belt retractor tension adjuster (1)
scientia non olet · About LEMON Manuals