LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1361 (Seat Belt System) >> Repair Instructions >> Seat Belt Height Adjuster Replacement - Front (Passenger Side) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Front Seat Shoulder Belt Retractor Tension Adjuster
    GM240010Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the front seat shoulder belt retractor tension adjuster (1) to the vehicle. Secure the adjuster with the bolt.

    Tighten:  Tighten the front seat shoulder belt retractor tension adjuster bolt to 42 N.m (31 lb ft).

  2. Install the center pillar upper trim panel. Refer to Trim Panel Replacement - Upper Center Pillar in Interior Trim.
  3. Install the center pillar lower trim panel. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  4. Install the seat belt shoulder guide. Refer to Seat Belt Retractor Replacement - Right Front .
  5. Install the front side door sill trim plate. Refer to Door Sill Plate Replacement .
  6. Install the rear side door sill trim plate. Refer to Door Sill Plate Replacement .
  7. Enable the passenger seat SIR System. Refer to SIR Disabling and Enabling Zone 9 in SIR.
scientia non olet · About LEMON Manuals