LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1361 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - Right Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inner Adjuster Finish Cover, Seat Belt Buckle, Screws And Bolts
    GM830097Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the seat belt buckle (2) to the front seat. Secure the buckle with the bolt (3).

    Tighten:  Tighten the front seat belt buckle bolt to 42 N.m (31 lb ft).

  2. Install the inner adjuster finish cover (4) to the front seat. Secure the cover with the 2 screws (1).
    3. Fig 2: Front Seat And Seat Belt Switch Electrical Connector
    GM743464Courtesy of GENERAL MOTORS CORP.
  3. Connect the seat belt switch electrical connector (2).
  4. Install the front floor rear console. Refer to Console Replacement - Rear Floor in Instrument Panel, Gages and Console.
  5. Return the front seat (1) to the upright position, if the left front buckle was removed.
scientia non olet · About LEMON Manuals