Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Rear Seat Belt Buckle

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear seat belt buckle (1) to the vehicle. Secure the buckle with the anchor bolt.
Tighten: Tighten the rear seat belt buckle anchor bolt to 42 N.m (31 lb ft).
Install the rear seat. Refer to Seat Replacement - Rear in Seats.