Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Child Seat Anchor Bracket, Rear Access Panel, Tether Anchor Covers And Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the child seat anchor bracket (4) to the vehicle. Secure the bracket with the bolt (3).
Tighten: Tighten the child seat anchor bracket bolt to 20 N.m (15 lb ft).
Install the rear access panel (2).