Fasten Safety Belt Indicator/Chime Always On (Driver)
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Fasten Safety Belt Indicator/Chime Always On (Driver)
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Seat Belt Schematics Connector End View Reference: Seat Belt Connector End Views |
|||
| 1 | Did you review the Seat Belt System Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Seat Belts |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 6 |
| 4 | Test the seat belt switch control circuit for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 8 | Go to Step 5 |
| 5 | Inspect for a poor connection of the harness connector at the instrument panel cluster. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 8 | Go to Step 7 |
| 6 | Replace the seat belt switch. Refer to Seat Belt Buckle Replacement - Left Front . Did you complete the replacement? |
Go to Step 8 | - |
| 7 | Replace the instrument panel cluster. Refer to Instrument Panel Cluster (IPC) Replacement
in Instrument Panel, Gages, and Console. Did you complete the replacement? |
Go to Step 8 | - |
| 8 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |