Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Sunroof Actuator And Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the sunroof actuator (4) to the vehicle. Secure the actuator with the 3 bolts (1).
Tighten: Tighten the sunroof actuator bolts to 5.4 N.m (48 lb in).
Connect the sunroof actuator electrical connector.
Install the headlining trim finish panel. Refer to Headliner Replacement in Interior Trim.