Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Sunroof Housing, Front Drain Hose And Body Hinge Pillar Panel

Courtesy of GENERAL MOTORS CORP.

Install the sunroof housing front drain hose (2) to the vehicle, by routing the hose down through the body hinge pillar panel (3).

Fig 2: Access Hole

Courtesy of GENERAL MOTORS CORP.

Make sure that the drain hose is in the correctly seated position in the lower portion of the body hinge pillar panel by positioning the hose through the access hole (1).

Fig 3: Body Hinge Pillar Panel And Connector Cavity

Courtesy of GENERAL MOTORS CORP.

Install the connector cavity (2) to the lower portion of the body hinge pillar panel (1).

Fig 4: Sunroof Housing, Front Drain Hose And Body Hinge Pillar Panel

Courtesy of GENERAL MOTORS CORP.

Install the body hinge pillar trim panel. Refer to Trim Replacement - Hinge Pillar in Interior Trim.
Install the sunroof housing front drain hose (2) to the sunroof housing (1). Secure the drain hose with the clamp.
Install the headlining trim finish panel. Refer to Headliner Replacement in Interior Trim.