Sunroof Switch Response

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

When pressing any of the sunroof switches, there is a normal momentary delay as to when the sunroof switch assembly supplies an output to drive the sunroof glass to the requested position. A request from a sunroof switch will only be recognized, clicking within the sunroof switch assembly, based on the input combinations from the sunroof limit switches. If the sunroof glass is in a vent position, the TILT switches will operate, while the SLIDE switches will be ignored. If the sunroof glass is in a any slide open position, both TILT switches will be ignored, while both SLIDE switches will operate. When the sunroof glass in the close position, only the TILT UP and SLIDE open switches will operate, as the TILT down and SLIDE close switches will be ignored.