LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1358 (HVAC Systems - Manual) >> Repair Instructions >> Temperature Control Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the radio. Refer to Radio Replacement in Entertainment.
    2. Fig 1: Center Console And Heater Control Trim Panel
    GM835770Courtesy of GENERAL MOTORS CORP.
  2. Remove the center knob from the HVAC control unit.
  3. Remove the screw from the control unit.
  4. Remove the center console and heater control trim panel (1).
    5. Fig 2: HVAC Mode Control Cable
    GM835774Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Note the routing of the cable to make installation easier.
  5. Disconnect the temperature control cable from the HVAC control unit.
  6. Disconnect the temperature control cable from the HVAC module assembly.
  7. Remove the temperature control cable from the vehicle.
scientia non olet · About LEMON Manuals