LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1358 (HVAC Systems - Manual) >> Repair Instructions >> Temperature Control Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: HVAC Mode Control Cable
    GM835774Courtesy of GENERAL MOTORS CORP.
  1. Position the temperature control cable in the vehicle. Route the cable as previously noted.
  2. Connect the temperature control cable to the HVAC module assembly.
  3. Connect the temperature control cable to the HVAC control unit.
    4. Fig 2: Center Console And Heater Control Trim Panel
    GM835770Courtesy of GENERAL MOTORS CORP.
  4. Install the center console and heater control trim panel (1).
  5. Install the screw to the control unit.
  6. Install the center knob to the HVAC control unit.
  7. Install the radio. Refer to Radio Replacement in Entertainment.
scientia non olet · About LEMON Manuals