LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1358 (HVAC Systems - Manual) >> Repair Instructions >> Recirculation Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Air Inlet Actuator, Connector And Screws
    GM840884Courtesy of GENERAL MOTORS CORP.
  1. Install the air inlet actuator (3) to the air inlet door shaft. The actuator can be installed on the shaft in two positions 180 degrees from each other. Ensure that the door is in the correct position for the actuator. Secure with the two screws (1).
  2. Install the connector (2).
  3. Install the Instrument Panel (IP) compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals