HVAC Compressor Clutch Does Not Disengage
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
HVAC Compressor Clutch Does Not Disengage
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: HVAC Schematics Connector End View Reference: HVAC Connector End Views |
|||
| 1 | Did you review the Air Delivery Description and Operation and the Air Temperature Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - HVAC Systems - Manual |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Remove the A/C compressor clutch relay from the underhood fuse block. Does the A/C compressor clutch disengage? |
Go to Step 5 | Go to Step 4 |
| 4 | Repair the short to voltage in the A/C compressor clutch supply voltage circuit. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 11 | - |
| 5 | Test the A/C compressor clutch relay. The switch should be normally open between terminals 1 and 3. Did the relay test OK? |
Go to Step 6 | Go to Step 8 |
| 6 |
|
Go to Step 9 | Go to Step 7 |
| 7 | Test the A/C compressor clutch relay control circuit for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 10 |
| 8 | Replace the A/C compressor relay. Refer to Compressor Relay Replacement
. Did you complete the replacement? |
Go to Step 11 | - |
| 9 | Replace the A/C switch. Refer to HVAC Control Assembly Replacement (Control Assembly) . Did you complete the replacement? |
Go to Step 11 | - |
| 10 | Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement
Engine-Engine Controls LNK or Powertrain Control Module (PCM) Replacement
Engine-Engine Controls LV6. Did you complete the replacement? |
Go to Step 11 | - |
| 11 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |