LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1357 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Shaft Coupling Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Shaft, Couplings, And Bolts
    GM820173Courtesy of GENERAL MOTORS CORP.
  1. If you are installing a new steering shaft coupling, copy the match mark (3) from the old coupling to the new coupling.
  2. Align the match marks and move the coupling (2) onto the steering column shaft (1).
  3. Align the match marks (3,4) and move the coupling onto the shaft (5).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the upper bolt (7) and the lower bolt (6) to the coupling.

    Tighten: 

    1. Tighten the lower bolt to 35 N.m (25.8 lb ft).
    2. Tighten the upper bolt to 35 N.m (25.8 lb ft).

  5. Place the silencer pad in the correct position.
scientia non olet · About LEMON Manuals