LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1357 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the trim covers from the steering column. Refer to Steering Column Trim Covers Replacement .
  3. Fig 1: Ignition Key Alarm Switch, Lock Cylinder, Ignition Switch, Cylinder Case, Case Clamp And Bolts
    GM820048Courtesy of GENERAL MOTORS CORP.
  4. Insert the key into the ignition lock cylinder (2).
  5. Turn the key to the ACC position.
  6. Use a screwdriver in order to push in the stop pin on the underside of the lock cylinder case (6).
  7. Remove the cylinder from the case.