Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Ignition Key Alarm Switch, Lock Cylinder, Ignition Switch, Cylinder Case, Case Clamp And Bolts

Courtesy of GENERAL MOTORS CORP.

Insert the key into the ignition lock cylinder (2).
Verify the key is in the ACC position.
Install the cylinder into the ignition lock cylinder case (6).
Verify the stop pin engages the case.
Remove the key from the cylinder.
Install the trim covers to the steering column. Refer to Steering Column Trim Covers Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.