LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1356 (Automatic Transmission - Mu5 (Introduction, Service & Replacement)) >> Repair Instructions >> Torque Converter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Torque Converter
    GM174736Courtesy of GENERAL MOTORS CORP.
  1. Install the Input shaft seal to input shaft.
  2. Install the following to the torque converter:
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    1. Install the torque converter seal to transmission.
    2. Install the converter seal bolts to transmission.

      Tighten:  Tighten the torque converter seals bolts to 3 N.m (26 lb in).

  3. Install the torque converter (1) to the transmission. Push the torque converter into position while rotating. The torque converter must be fully seated.
  4. Install the transmission. Refer to Transaxle Replacement .
scientia non olet · About LEMON Manuals