LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1356 (Automatic Transmission - Mu5 (Introduction, Service & Replacement)) >> Repair Instructions >> Park/Neutral Position Switch >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Manual Lever
    GM857097Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Remove the battery. Refer to Battery Replacement in Engine Electrical.
  2. Remove the 4 battery tray retaining bolts, then remove the battery tray from the vehicle.
  3. Remove the shift cable retaining clip, then disconnect the cable from the bracket.
  4. Remove the shift cable retaining nut, then disconnect the cable from the manual lever.
    5. Fig 2: PNP Switch Electrical Connector
    GM242877Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the PNP switch electrical connector (1) from the PNP switch.
    6. Fig 3: Lock Plate And Manual Shaft Nut
    GM857099Courtesy of GENERAL MOTORS CORP.
  6. Remove 1 nut, 1 lock washer and the manual lever from the manual shaft.
  7. Unstake the lock plate (1) behind the manual shaft nut (3).
  8. Remove the manual shaft nut and the lock plate from the PNP switch.
  9. Remove the 2 bolts and the PNP switch from the transaxle.
scientia non olet · About LEMON Manuals