LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1356 (Automatic Transmission - Mu5 (Introduction, Service & Replacement)) >> Repair Instructions >> Front Wheel Drive Shaft Oil Seal Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transfer case assembly from the vehicle. Refer to Transfer Case Replacement in Transfer Case - Vibe.
    2. Fig 1: Removing Transfer Case Oil Seal From Transaxle
    GM890351Courtesy of GENERAL MOTORS CORP.
  2. Using a screwdriver, remove the transfer case oil seal from the transaxle.
    3. Fig 2: Differential Case Oil Seal
    GM890354Courtesy of GENERAL MOTORS CORP.
  3. Using J 26941  with J 23907  , remove the differential case oil seal.
  4. Inspect the differential-side joint surface of the drive axle assembly where the drive axle makes contact with the drive axle shaft seal.

    The surface should be smooth and free of any burrs or scarring which may damage the drive axle shaft fluid seal.

    If damage to the differential-side joint is evident, replace the differential-side joint.

scientia non olet · About LEMON Manuals