LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1356 (Automatic Transmission - Mu5 (Introduction, Service & Replacement)) >> Repair Instructions >> Front Wheel Drive Shaft Oil Seal Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The install depth for the differential case oil seal is approximately 0.5 mm (0.020 in.)
  1. Install the new differential case oil seal in the transaxle.
    2. IMPORTANT: The install depth for the transfer case oil seal is approximately 2.5 mm (0.098 in.)
  2. Install the transfer case oil seal in the transaxle.
  3. Apply J 36850  to the new drive axle seal lip.
  4. Install the transfer case assembly. Refer to Transfer Case Replacement in Transfer Case - Vibe.
scientia non olet · About LEMON Manuals