LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1356 (Automatic Transmission - Mu5 (Introduction, Service & Replacement)) >> Diagnostic Information and Procedures >> DTC P0717 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

The PCM compares the output shaft speed with the input/turbine speed sensor. When the output shaft speed is higher than the calculated value and the input shaft speed is 300 RPM or less while the vehicle is running and in the Drive (D) position, the PCM will determine that there is a malfunction of the input/turbine speed sensor.

One driving cycle detection logic

scientia non olet · About LEMON Manuals