Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Horn Bracket, Horn And Nuts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the horn (3) to the bracket (1), if removed. Secure the horn with the nut (2).
Tighten: Tighten the horn retaining nut to 10 N.m (89 lb in).

Fig 2: Bracket With Horn Attached

Courtesy of GENERAL MOTORS CORP.

Install the horn (2) and bracket to the vehicle. Secure the bracket with the bolt.
Tighten: Tighten the horn bracket mounting bolt to 10 N.m (89 lb in).
Connect the horn electrical connector.