LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1353 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Raise and properly support the engine. Refer to Lifting and Jacking the Vehicle in General Information.
    3. Fig 1: Engine Mount, Nuts And Bolts
    GM879247Courtesy of GENERAL MOTORS CORP.
  3. Remove the right side engine mount-to-engine bracket bolts and nuts (1).
  4. Remove the 3 right side engine mount-to-frame bolts.
  5. Raise the engine slightly in order to provide clearance for the engine mount assembly removal.
  6. Remove the right side engine mount from the vehicle.
  7. Remove the right side engine mount-to-frame bracket from the engine mount.
  8. Remove the right side engine mount-to-engine bracket from the engine mount.
scientia non olet · About LEMON Manuals