LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1353 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount, Nuts And Bolts
    GM879247Courtesy of GENERAL MOTORS CORP.
  1. Install the right side engine mount-to-engine bracket to the engine mount.
  2. Install the right side engine mount-to-frame bracket to the engine mount.
  3. Install the right side engine mount to the engine.
  4. Install the three right side engine mount-to-frame bolts. Do not fully tighten the bolts.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the 3 right side engine mount-to-engine bracket bolt and nuts.

    Tighten: 

    • Tighten the right side engine mount-to-frame bolts (1) to 52 N.m (38 lb ft).
    • Tighten the right side engine mount-to-engine bracket bolt and nuts (3) to 54 N.m (40 lb ft).

  6. Remove the engine support fixture.
  7. Connect the negative battery cable.

    Tighten:  Tighten the battery cable bolt to 15 N.m (11 lb ft).

scientia non olet · About LEMON Manuals