LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1353 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Block Heater Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Heater Cartridge
    GM890228Courtesy of GENERAL MOTORS CORP.
  1. Fully seat the heater cartridge against the engine block and ensure the retaining clip snaps in place. The final orientation of the wire harness should be in the 3 o'clock position. Turn the retaining clip 90 degrees from the wire harness to the 12 o'clock position.
  2. Ensure the wire harness cartridge plug is fully seated onto the cartridge.
  3. Ensure the main wire harness clip (1) is fully seated.
    4. Fig 2: Main Wire Harness
    GM890190Courtesy of GENERAL MOTORS CORP.
  4. Route the heater wire harness as shown.
    5. Fig 3: Headlamp Tab And Battery
    GM890171Courtesy of GENERAL MOTORS CORP.
  5. Tuck the heater wire harness below the junction box on the outside of the battery.
  6. Tuck the 110V heater plug in the space in between the battery and headlamp assembly (1).
  7. Clip the heater wire harness on the outside of the battery (2).
  8. Ensure that the 110V plug tie-strap securely holds the wire bundle and the protector cap is fully seated on the plug.
scientia non olet · About LEMON Manuals