LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1353 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Guide Tube Seal, Guide Tube And Bolts
    GM236501Courtesy of GENERAL MOTORS CORP.
  1. Use new engine oil in order to coat the new guide tube seal.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the new guide tube seal (1) to the guide tube. Secure the guide tube to the cylinder block using one bolt (3).

    Tighten:  Tighten the bolt to 24 N.m (18 lb ft).

  3. Install the oil level indicator to the guide tube.
scientia non olet · About LEMON Manuals