LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1353 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Intake Manifold Installation

Intake Manifold Installation

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the intake manifold and new gasket.
  2. Install the 2 bolts to the alternator bracket.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Intake Manifold Bolts And Nuts
    GM828279Courtesy of GENERAL MOTORS CORP.
  3. Install the intake manifold bolts and nuts.

    Tighten:  Tighten the upper intake manifold nuts and the bolts to 34 N.m (25 lb ft).

    Tighten:  Tighten the lower intake manifold bolt to 46 N.m (34 lb ft).

  4. Install 2 bolts and 1 nut to the intake manifold support bracket.

    Tighten:  Tighten the intake manifold support bracket bolts to 24 N.m (18 lb ft).

  5. Install the oil dipstick guide bolt.

    Tighten:  Tighten the oil dipstick guide bolt to 24 N.m (18 lb ft).

  6. Connect the brake booster vacuum hose.
  7. Connect the EVAP hose for the ORVR.
scientia non olet · About LEMON Manuals