LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1353 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Exhaust Manifold Cleaning and Inspection

Exhaust Manifold Cleaning and Inspection

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Do not reuse the exhaust manifold-to-cylinder head gaskets. Upon installation of the exhaust manifold, install a NEW gasket. An improperly installed gasket or leaking exhaust system may effect On-Board Diagnostics (OBD) II system performance.
  • Inspect the exhaust manifold for cracks near the mounting holes (1-5).
    Fig 1: Exhaust Manifold Bolts
    GM234429Courtesy of GENERAL MOTORS CORP.
  1. Clean the exhaust manifold with solvent.
    2. CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
  2. Dry the exhaust manifold with compressed air.
    3. Fig 2: Cleaning Exhaust Manifold Mating Surface
    GM235498Courtesy of GENERAL MOTORS CORP.
  3. Clean the exhaust manifold mating surface.
  4. Use a straight edge and a feeler gage and measure the exhaust manifold mounting face for warpage.

    Exhaust Manifold Maximum Warpage:  0.70 mm (0.0276 in)

  5. If the warpage is greater than the maximum, replace the exhaust manifold.
scientia non olet · About LEMON Manuals