LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1353 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Camshaft Installation - Intake

Camshaft Installation - Intake

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Intake Camshaft
    GM235547Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When performing any service procedure that pertains to the camshaft or the camshaft actuator, unlock the camshaft actuator locking pin. Refer to Camshaft Actuator Locking Pin Adjustment .
  1. Install the intake camshaft onto the cylinder head with the number 1 cam lobes facing as shown.
    2. IMPORTANT: Each bearing cap has a number and a directional arrow marked on the bearing cap.
  2. Install the camshaft bearing caps in their proper locations with the arrows facing forward.
    3. Fig 2: Camshaft Bearing Cap Bolts
    GM886576Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the camshaft bearing cap bolts.

    Tighten:  Tighten the bolts in the sequence shown to 19 N.m (14 lb ft).

  4. Install the camshaft timing gear and camshaft bearing cap and secure with the bolts.

    Tighten:  Tighten the bolts to 19 N.m (14 lb ft).

    5. Fig 3: View Of Sprocket Locating Pins
    GM625493Courtesy of GENERAL MOTORS CORP.
  5. Install the intake camshaft sprocket to the camshaft.
  6. Install the intake camshaft sprocket bolt to the camshaft.

    Tighten:  Tighten the bolt to 54 N.m (40 lb ft).

  7. Unlock the intake camshaft actuator locking pin. Refer to Camshaft Actuator Locking Pin Adjustment .
scientia non olet · About LEMON Manuals