LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1352 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Pump And Gasket
    GM236064Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Engage the ridges of the oil pump drive rotor with the flat sections of the crankshaft.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the oil pump. Use a new oil pump gasket.
  2. Use the five oil pump bolts in order to secure the oil pump.

    Tighten:  Tighten the oil pump bolts to 11 N.m (97 lb in).

  3. Install the timing chain. Refer to Timing Chain and Sprockets Replacement .
scientia non olet · About LEMON Manuals