LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1352 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Support Fixture >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the windshield wiper arms. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
  2. Raise the hood.
  3. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
    4. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  4. Disconnect the negative battery cable.
  5. Install the thread support adaptors (J 28467-Vibe) onto the strut attaching studs.
  6. Install the strut tower support assemblies (J 28467-5A) over the thread support nuts (J 28467-33A).
  7. Install the T-bolts (J 28467-53) with 5/16 inch washers through the strut tower support assemblies (J 28467-5A) into the thread support nuts (J 28467-33A) and hand tighten.
  8. Install the two cross bracket assemblies (J 28467-1A) over the strut tower tube (J 28467-3).
  9. Install the strut tower tube (J 28467-3) into the strut tower support assemblies (J 28467-5A).
  10. Install the 1/2 inch x 2.5 inch quick release pin (J 28467-10) through the strut tower support assemblies (J 28467-5A) and the strut tower tube (J 28467-3) on one side only.
  11. Hand tighten the passenger side cross bracket assembly (J 28467-1A) wing nuts.
  12. Hand tighten the lift hook wing nut securely to remove all slack from the engine support fixture assembly.
scientia non olet · About LEMON Manuals