LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1352 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the accessory drive belt. Refer to Drive Belt Replacement .
  3. Place a jack under the engine. Be sure to place a block of wood between the jack and the engine.
  4. Remove the right side engine mount. Refer to Engine Mount Replacement .
  5. Using the jack, raise the engine assembly.
    6. Fig 1: Lower Drive Belt Tensioner Bolt
    GM234378Courtesy of GENERAL MOTORS CORP.
  6. Remove the lower drive belt tensioner bolt (6).
  7. Remove the upper drive belt tensioner nut and slide the assembly off the stud.
scientia non olet · About LEMON Manuals