LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1352 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the right side lower engine splash shield.
  3. Properly route and install the accessory drive belt onto the drive pulleys.
    4. Fig 1: Identifying Serpentine Drive Belt Routing
    GM244267Courtesy of GENERAL MOTORS CORP.
  4. Use a wrench and rotate the belt tensioner clockwise.
  5. With pressure applied to the wrench, install the accessory drive belt.
  6. With the accessory drive belt installed properly, release the belt tensioner.
  7. Install the right side lower engine splash shield.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Connect the negative battery cable.

    Tighten:  Tighten the battery cable bolt to 15 N.m (11 lb ft).

scientia non olet · About LEMON Manuals