Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Apply multi-purpose grease to the new crankshaft rear oil seal lip.
- Using a hammer, lightly tap the crankshaft rear oil seal into place.
- Install the flywheel. Refer to Engine Flywheel Replacement .
- If equipped with a manual transmission, install the clutch and pressure plate. Refer to Clutch Assembly Replacement in Clutch.
- Install the transaxle assembly. Refer to the following:
- Transaxle Replacement in Automatic Transmission - MU5 for all wheel drive automatic transaxle
- Transaxle Replacement in Automatic Transmission - MU4 for 4-speed automatic transaxle
- Transaxle Replacement in Manual Transmission - MK5 for 5-speed manual transaxle
- Transaxle Replacement in Manual Transmission - MTN for 6-speed manual transaxle
- Connect the negative battery cable.
Tighten: Tighten the battery cable bolt to 15 N.m (11 lb ft).
IMPORTANT:
Tap the oil seal in until its surface is flush with the crankshaft rear oil seal retainer edge.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.