LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1352 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the front seal and the sealing surface of the crankshaft pulley with Chassis Grease GM P/N 1051344 (Canadian P/N 993037) or equivalent.
  2. Install the crankshaft pulley onto the crankshaft indexing keyway.
    3. Fig 1: Installing Crankshaft Pulley
    GM234382Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the crankshaft pulley retaining bolt using J 8614-01  to prevent crankshaft rotation when tightening the bolt.

    Tighten:  Tighten the bolt to 142 N.m (105 lb ft).

  4. Install the right splash shield.
  5. Lower the vehicle.
  6. Install the accessory drive belt. Refer to Drive Belt Replacement .
  7. Connect the negative battery cable.

    Tighten:  Tighten the battery cable bolt to 15 N.m (11 lb ft).

scientia non olet · About LEMON Manuals