LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1352 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Crankshaft Front Oil Seal Installation

Crankshaft Front Oil Seal Installation

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Oil Seal
    GM234210Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the new crankshaft front oil seal with Chassis Grease GM P/N 1051344 (Canadian P/N 993037) or equivalent.
    2. IMPORTANT: Tap the oil seal in until its surface is flush with the crankshaft rear oil seal retainer edge.
  2. Using a hammer, lightly tap the crankshaft front oil seal into place.
scientia non olet · About LEMON Manuals