LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1348 (Engine Control System (Introduction) -- 1.8L (LNK)) >> Repair Instructions >> Evaporative Emission (EVAP) Pressure Switching Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the EVAP pressure switching solenoid and the EVAP control system for carbon particle contamination before replacing the EVAP pressure switching solenoid.
    2. Fig 1: Canister, Pressure Switching Solenoid, And Fasteners
    GM625291Courtesy of GENERAL MOTORS CORP.
  2. Install the EVAP pressure switching solenoid (1) to the EVAP canister.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Secure the solenoid with the fastener (2).

    Tighten:  Tighten the fastener to 8.8 N.m (77 lb in).

  4. Connect the 2 vapor hoses.
  5. Connect the electrical connector.
  6. Install the EVAP canister (3). Refer to Evaporative Emission (EVAP) Canister Replacement .
scientia non olet · About LEMON Manuals