LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1348 (Engine Control System (Introduction) -- 1.8L (LNK)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Disconnecting ORVR Vent Line
    GM832028Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the ORVR vent line (1) from the EVAP canister port by pinching both sides of the hose connector (1).
    3. Fig 2: Disconnecting EVAP Vapor Line
    GM832244Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the EVAP vapor line (1) from the EVAP canister port by pinching both sides of the hose connector (1).
    4. Fig 3: EVAP Canister, Electrical Connector, EVAP Hoses And Bolts
    GM832241Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the 3 EVAP hoses (3) from the EVAP canister (1).
  5. Disconnect the electrical connector (4) from the EVAP pressure switching solenoid.
  6. Remove the 3 bolts (2) and the EVAP canister (1) from the vehicle.
  7. Inspect the EVAP purge system for carbon particle contamination before replacing the EVAP canister.
scientia non olet · About LEMON Manuals