LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1348 (Engine Control System (Introduction) -- 1.8L (LNK)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister, Electrical Connector, EVAP Hoses And Bolts
    GM832241Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister (1) to the vehicle underbody and secure with the 3 bolts (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the EVAP canister bracket support bolts.

    Tighten:  Tighten the bolts to 19 N.m (14 lb ft).

  3. Connect the 3 EVAP hoses (3) to the EVAP canister (1).
  4. Connect the electrical connector (4) to the EVAP pressure switching solenoid.
    5. Fig 2: Disconnecting EVAP Vapor Line
    GM832244Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP vapor line (1) to the EVAP canister port by pinching both sides of the hose connector (1).
    6. Fig 3: Disconnecting ORVR Vent Line
    GM832028Courtesy of GENERAL MOTORS CORP.
  6. Connect the ORVR vent line (1) to the EVAP canister port by pinching both sides of the hose connector (1).
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals