LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1348 (Engine Control System (Introduction) -- 1.8L (LNK)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Connector, Purge Valve, Purge Hose And Vacuum Hose
    GM832001Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector (1) from the EVAP canister purge valve (2).
  2. Remove the purge hose (3) from the EVAP canister purge valve (2).
  3. Remove the vacuum hose (4) from the EVAP canister purge valve (2).
  4. Remove the EVAP canister purge valve from the air cleaner housing.
  5. Inspect the EVAP canister purge valve and the EVAP purge system for carbon particle contamination before replacing the EVAP canister purge valve.
scientia non olet · About LEMON Manuals