LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1348 (Engine Control System (Introduction) -- 1.8L (LNK)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: CKP Sensor And Hold Down Bolt
    GM181701Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor (1) into the front cover of the engine block.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor hold down bolt (2).

    Tighten:  Tighten the hold down bolt to 9 N.m (80 lb in).

  3. Connect the CKP sensor electrical connector.
    4. Fig 2: Stone Shield, Four Retainers And Two Bolts
    GM830841Courtesy of GENERAL MOTORS CORP.
  4. Install the stone shield (1) with the four retainers (2).
  5. Secure the stone shield (1) with the two bolts (3).

    Tighten:  Tighten the two shield bolts to 10 N.m (89 lb in).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals