LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1348 (Engine Control System (Introduction) -- 1.8L (LNK)) >> Repair Instructions >> Auxiliary Intake Air Control Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Connector, Vacuum Lines, Air Control Solenoid And Fasteners
    GM833867Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the auxiliary intake air control solenoid (3) to the air cleaner housing with the two fasteners (4).

    Tighten:  Tighten the fasteners to 3.7 N.m (33 lb in).

  2. Connect the 2 vacuum hoses (2) to the auxiliary intake air control solenoid (3).
  3. Connect the electrical connector.
scientia non olet · About LEMON Manuals