LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1347 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent as damage may result.
    Fig 1: TP Sensor, Fasteners And Electrical Connectors (AWD)
    GM229615Courtesy of GENERAL MOTORS CORP.
  1. Remove the 2 fasteners (3) from the throttle position (TP) sensor (2).
  2. Remove the TP sensor (2) from the throttle body.
scientia non olet · About LEMON Manuals