Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Throttle Body, TP Sensor And Throttle Shaft (AWD)

Courtesy of GENERAL MOTORS CORP.

Align the throttle shaft (3) with the slot in the TP sensor (2).
Install the TP sensor (2) to the throttle body (1).

Fig 2: Fasteners And Electrical Connectors (AWD)

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Secure the TP sensor with the 2 fasteners (3).
Tighten: Tighten the fasteners to 2.0 N.m (18 lb in).