LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1347 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement (FWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: FTP Sensor And Fuel Sender Electrical Connector (FWD)
    GM828297Courtesy of GENERAL MOTORS CORP.
  1. Remove the two fasteners and swing the rear seat bottom cushion up and out of the way. Refer to Seat Cushion Replacement - Rear in Seats.
  2. Remove the sill plate from the left side door opening.
  3. Fold back the carpet in order to maintain metal-to-metal contact while servicing the fuel sender assembly.
  4. Remove the access panel for the fuel sender assembly from the rear seat floor. The panel is held in place by a butyl caulk seal.
  5. Disconnect the fuel sender electrical connector (1) from the fuel sender assembly.
  6. Disconnect the electrical connector of the fuel tank pressure (FTP) sensor (2) from the fuel sender assembly.
    7. Fig 2: FTP Sensor And Retaining Clip (FWD)
    GM828936Courtesy of GENERAL MOTORS CORP.
  7. Remove the retaining clip (2) from the FTP sensor.
  8. Remove the FTP sensor (1) from the fuel sender assembly.
scientia non olet · About LEMON Manuals