Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Relieve the fuel pressure. Refer to the Fuel Pressure Relief Procedure (FWD) or Fuel Pressure Relief Procedure (AWD) .
- Remove the J 34730-1A from the J 42982 .
- Using the J 43178 , disconnect the quick connect coupling of the J 42982 from the fuel feed pipe of the fuel rail. Use a shop towel in order to catch any remaining fuel that may leak.
- Disconnect the quick connect coupling of the fuel feed hose from the J 42982 , and remove the adapter. Use a shop towel in order to catch any remaining fuel that may leak.
- Connect the quick-connect fitting of the fuel feed hose (1) to the fuel feed pipe (2) of the fuel rail. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
- Install the cover for the quick connect coupling of the fuel feed hose.
- Connect the negative battery cable.
Tighten: Tighten the retainer for the negative battery cable terminal to 15 N.m (11 lb ft).
- Turn ON the ignition in order to pressurize the fuel system.
- Turn OFF the ignition.
- Check for any fuel leaks.
- Install the engine cover (1).
- Secure the engine cover (1) with the 2 fasteners.
Tighten: Tighten the two fasteners to 7 N.m (62 lb in).
- Install the 2 plastic retainers.
NOTE:
Refer to Fastener Notice in Cautions and Notices.