LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1347 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Fill Limiter Vent Valve Replacement (FWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: FLVV Gasket In Fuel Tank (FWD)
    GM851886Courtesy of GENERAL MOTORS CORP.
  1. Install the FLVV gasket (1) into the fuel tank.
    2. Fig 2: Light Coat Of Motor Oil To Sealing Edge Of FLVV (FWD)
    GM851887Courtesy of GENERAL MOTORS CORP.
  2. Apply a light coat of motor oil to the sealing edge of the FLVV.
  3. Install the FLVV into the fuel tank while keeping the correct alignment for the hose connections.
  4. Place the FLVV cover onto the FLVV and rotate the cover clockwise until the lock tab is in position and engaged.
  5. Install the fuel tank. Refer to Fuel Tank Replacement (FWD)  or Fuel Tank Replacement (AWD) .
scientia non olet · About LEMON Manuals