LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1347 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The EVAP canister may have released carbon particles which caused this part to fail and may cause damage to other components. Check the EVAP canister for loose carbon before returning the vehicle to service.
    Fig 1: Canister Vent Valve, Vent Hose, Electrical Connector And Fastener
    GM832000Courtesy of GENERAL MOTORS CORP.
  1. Remove the one vent hose (4) from the air cleaner and the EVAP canister vent valve (3).
  2. Disconnect the other vent hose (4) from the EVAP canister vent valve (3).
  3. Disconnect the electrical connector (1) from the EVAP canister vent valve (3).
  4. Remove the fastener (2) from the EVAP canister vent valve (3).
  5. Remove the EVAP canister vent valve (1) from the air cleaner housing.
  6. Inspect the EVAP canister vent valve and the EVAP vent system for carbon particle contamination before replacing the EVAP canister vent valve.
scientia non olet · About LEMON Manuals