LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1347 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Disconnect/Connecting ORVR Vent Line Of Hose Connector (AWD)
    GM832027Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the ORVR vent line (1) from the EVAP canister port by pinching both sides of the hose connector (1).
    3. Fig 2: Disconnect/Connecting EVAP Vapor Line Of Hose Connector (AWD)
    GM832227Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the EVAP vapor line (1) from the EVAP canister port by pinching both sides of the hose connector (1).
    4. Fig 3: Disconnecting/Connecting EVAP Canister, Electrical Connector, EVAP Hoses And Bolts (AWD)
    GM832235Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the 3 EVAP hoses (1) from the EVAP canister (3).
  5. Disconnect the electrical connector (4) from the EVAP pressure switching solenoid.
  6. Remove the 3 bolts (2) and the EVAP canister (3) from the vehicle.
  7. Inspect the EVAP purge system for carbon particle contamination before replacing the EVAP canister.
scientia non olet · About LEMON Manuals