LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1347 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Engine Coolant Temperature (ECT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: ECT Sensor Electrical Connector And ECT Sensor
    GM641349Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Component Fastener Tightening Notice in Cautions and Notices.
  1. Install the ECT sensor (2) into cylinder head.

    Tighten:  Tighten the ECT sensor to 20 N.m (14 lb ft).

  2. Connect the ECT sensor electrical connector (1).
  3. Refill the engine coolant. Refer to Draining and Filling Cooling System in Engine Cooling.
scientia non olet · About LEMON Manuals